Download Advantech PCM-3353 User manual

3.6.2 Integrated peripherals screen
3.6.3 Onboard LAN Control
Options are Enable or Disable. Select Disable if user does not want to use
onboard LAN controller1
3.6.4 IDE HDD Block Mode
You can enable the Primary IDE channel and/or the Secondary IDE channel. Any channel not enabled is disabled. This field is for systems with
only SCSI drives.
3.6.5 Onboard Serial Port
For settings reference the Appendix for the serial resource allocation,
and Disabled for the on-board serial connector
3.6.6 Onboard Parallel Port
This field sets the address of the onboard parallel port connector. You can
select either 3BCH/IRQ7, 378H/IRQ7, 278H/IRQ5 or Disabled. If you
install an I/O card with a parallel port, make sure there is no conflict in
the address assignments. The CPU card can support up to three parallel
ports, as long as there are no conflicts for each port.
3.6.7 Parallel Port Mode
This field allows you to set the operation mode of the parallel port. The
setting “Normal” allows normal speed operation, but in one direction
only. “EPP” allows bidirectional parallel port operation at maximum
speed. “ECP” allows the parallel port to operate in bi-directional mode
and at a speed faster than the maximum data transfer rate. “ECP + EPP”
allows normal speed operation in a two-way mode.
23
Chapter 3