1
Download Citizen BD2-1220 User`s manual
Transcript
BD2-1220/1221 User’s Manual 8. ERROR HANDLING This section describes some typical errors that could be detected on the control board at power on (initialization) or during printer operation. Error status can be known from the nERROR and nPEOUT signals. (The following describes errors that are identified by LED lights.) In the event of an error, the BUSY (DTR), PE, FAULT, SELECT, or some other signals may be activated as well as the ERROR and/or PEOUT signals described in the following table. The BUSY (DTR) signal depends on jumper (J6) setting, however. 8.1 List of Error Indications Error indication ERROR Memory Check Error Head Up Quick blinking Lights Head Overheat Paper Near End Paper End Slower blinking Off Lights Cutter Motor Lockup PEOUT Off Unrecoverable Off Head-down Off Automatically recovered when head cools down. Lights Lights Low Voltage Slow blinking Lights High Voltage Quick & slow blinking 21 Load paper. Load paper. Off Unrecoverable (remove paper jam) Off Set the LF-SW signal to Low. Off Unrecoverable Off Unrecoverable Quick & slow blinking Waiting for Macro Error Recovery
