Download ASCOM Eurit 33 Plus Operating instructions

Eurit 33 plus remote access
Introduction
You can call up and remotely control your TAM from any telephone i.e.
– Listen to and delete messages
– Switch the TAM on or off
– Record or change greetings.
DTMF is used for remote access to the TAM. You can perform the required procedure either
with a telephone with DTMF or multi-frequency dialling function, or with a code sender
(handheld transmitter).
Note that for remote access:
– Remote access of the TAM functions only if a remote access PIN code has been activated.
– Remote access of the TAM is terminated when you replace the handset.
– Pauses between entering digits must be no longer than 9 seconds, otherwise the remote
access procedure is aborted.
– To resume to basic remote access status or abort a function, press key 2.
– The remote access PIN code must be entered while the greeting is being played.
Attention: »Call forwarding permanent« must be deactivated, otherwise your remote
access call will be directly forwarded to the defined number (see »Call forwarding«).
20312912en_ba_a0
➭
67