Download Technical Documentation Project : CopperJet History

© 2000 Allied Data Technologies
Description:
If 1, use an HDLC header on the front of transmitted packets and require one on received
ones. This consists of two bytes, FF-03, and assists in interoperability with some other (nonstandard) implementations. If 0, disable this. Call with no argument to find the current setting.
The default value is 0 (disabled). Configuration saving saves this information.
If not set, and a packet is received with an HDLC header, the channel goes into a ‘learned
HDLC’ mode and sends packets with the HDLC header. Thus, interoperation with HDLCusing equipment should not normally require any configuration. Learning occurs in this
direction only. Setting hdlc to 0 clears this learned state. Configuration saving does not save
the learned state.
6.9
<channel> info
Syntax:
<channel> info [all]
Description:
Provide information about the current settings of this channel. This includes all configured
state, and also current protocol information. Specifying ‘all’ prints out more information.
info and status are synonyms.
6.10 <channel> interface
Syntax:
<channel> interface <n>
Description:
Logically associate the specified channel with the specified interface. Interface 1 is always the
router port. It should be used for any PPP channel over which IPCP communication with the
local system’s IP router is desired. Other interfaces can be created for bridging. A single PPP
channel can only be associated with a single interface, or a single tunnel. Use info to find
the current setting. Calling with n=0 removes any association. This is the default state.
Configuration saving saves this information.
See also:
<channel> info
<channel> tunnel <n>
6.11 <channel> lcpmaxconfigure
Syntax:
<channel> lcpmaxconfigure [<n>]
Description:
Set the Max-Configure parameter for LCP, as described in section 4.6 of RFC1661. This is
the maximum number of Configure Requests that will be sent without reply, before assuming
that the peer is unable to respond. Call with no argument to find the current setting.
The default value is 10. Configuration saving saves this information.
6.12 <channel> lcpmaxfailure
Syntax:
<channel> lcpmaxfailure [<n>]
Description:
15-08-00
This document is not officialy released and has to be treated as confidential.
page 23 of 98