Download E-Lins E481 Series Specifications

Communication
■
GPADR: gives the device address to be used for GPIB (IEEE 488)
communication,
default is 4
also accessible as GPIB Address parameter, ID 0x11000900
■
IPADR: the first four portions specify the default IP address for
TCP/IP communication, the last portion specifies the default port to
be used,
default is 192.168.168.10:50000
also accessible as IP Address parameter, ID 0x11000600
Note: While the IP address can be changed, the port must always be
50000!
■
IPSTART: defines the startup behavior for configuration of the IP
address for TCP/IP communication,
default is 1 = "use DHCP to obtain IP address"
also accessible as IP Configuration parameter, ID 0x11000800
■
IPMASK: gives the IP mask to be used for TCP/IP communication,
default is 255.255.255.0
also accessible as IP Mask parameter, ID 0x11000700
■
MACADR: is the unique address of the network hardware in the
E-517, read-only, example:
0-d0-c9-a7-1f-86
also accessible as MAC Address parameter, ID 0x11000B00
NOTES
A TCP/IP connection will fail if no DCHP server is present but the
startup behavior for IP address configuration is set to "use DHCP to
obtain IP address, if this fails, use IPADR" (IPSTART = 1). The E-517
will use the address given by IPADR only if IPSTART = 0.
If the IP address for the current TCP/IP connection was obtained from
a DHCP server, this address is not reflected in the response to the
IFC? command.
The currently active RS-232 baud rate and GPIB (IEEE 488) address
can also be checked/set on the E-517 front panel in the
COMMUNICATION display screen (p. 21). This screen can be
accessed by the trackball (p. 22). The front panel settings correspond
with the communication parameter settings described above.
www.pi.ws
E-517 PZ214Equ Release 1.0.0
Page 47