Download Agilent Technologies PSG Programming instructions

Command Reference
List/Sweep subsystem ([:SOURce])
:LIST:FREQuency:POINts
Supported
All
[:SOURce]:LIST:FREQuency:POINts?
This command queries the current list sweep file for the number of frequency points.
*RST
N/A
Range
N/A
Key Entry
N/A
Remarks
N/A
:LIST:MANual
Supported
All
[:SOURce]:LIST:MANual <val>
[:SOURce]:LIST:MANual?
This command sets a list or step sweep point as the current sweep point controlling the
frequency and power output.
*RST
Ν/Α
Range
1−1601
Key Entry
Manual Point
Remarks
If list or step mode is controlling frequency and/or power, then the
indexed point in the respective list(s) will be used.
Entering a value with this command will have no effect, unless
MANual is the selected mode. Refer to “:LIST:MODE” on page 258 for
setting the proper mode.
If the point selected is beyond the length of the longest enabled list,
then the point will be set to the maximum possible point, and an error
will be generated.
Chapter 4
257