Download Dell S50V Specifications

Transcript
Installing SFP Transceivers (optional)
To install 1Gbps SFPs (Small
Form-factor Pluggable optical
transceivers) into the four
open ports at the right front of
the S50V:
1.
2. Insert the SFP into the
port until it gently snaps
into place.
fn00162s50V
Position the SFP so that
the bail is closed and on
top of the SFP.
Note: The four SFP ports
shown in the graphic, when
populated, automatically
preempt the four copper ports
labeled 45 through 48.
In other words, while you use
a particular optical port, you
cannot use the equivalent
copper port.
Note: For details on SFP and XFP optics supported by Force10, see
http://www.force10networks.com/products/specifications.asp
Installing XFP Transceivers (optional)
Warning: Do not look directly into any optical port. Failure to follow this warning could result in
physical harm.
The two module slots on the back of the S50V both
accept optional 10-Gigabit modules.
To install an XFP transceiver into an XFP port (in the
fiber optical version of the 10-Gigabit module):
1.
Position the XFP so that the bail is closed and on
top of the XFP.
2. Insert the XFP into the port until it gently snaps
into place.
10
Installing the Hardware