Download Ericsson SPR1100 Operating instructions

Technical Specification
B.7.2
EMC 2
The equipment has been designed and tested to meet the following:
B.7.3
EN 55022
and
CISPR22
European
EN 61000-3-2 3
European
Electromagnetic Compatibility (EMC), Part 3
Limits; Section 2. Limits for harmonic current
emissions (equipment input current  16 A
per phase).
EN 61000-3-33
European
Electromagnetic Compatibility (EMC), Part 3.
Limits; Section 3. Limitation of voltage
fluctuations and flicker in low voltage supply
systems for equipment with rated current 
16 A.
EN 55024
European
Information technology equipment - Immunity
characteristics - Limits and methods of
measurement.
FCC
USA
Conducted and radiated emission limits for a
Class A digital device, pursuant to the Code
of Federal Regulations (CFR) Title
47-Telecommunications, Part 15: Radio
frequency devices, subpart B - Unintentional
Radiators.
International
Emission Standard
Limits and methods of measurement of radio
frequency interference characteristics of
information technology equipment - Class A.
Telecommunications
If certain Option Modules (telecom interfaces) are fitted, this equipment comes
within the scope of the RTTE Directive, 1999/5/EC. Compliance with the applicable
essential requirements of this Directive (safety and EMC) are met by conformance
with the safety and EMC standards listed above.
B.7.4
CE Marking
The CE mark is affixed to indicate compliance with the following directives:
Low Voltage Directive (LVD): Directive 2006/95/EC of 12 December 2006 on the
harmonization of the laws of Member States relating to electrical equipment
designed for use within certain voltage limits.
Electromagnetic Compatibility (EMC) Directive: Directive 2004/108/EC of 15
December 2004 on the approximation of the laws of the Member States relating
2
3
The EMC tests were performed with the Technical Earth attached, and configured using recommended cables).
Applies only to models of the Product using AC power sources.
2/1553-FGC 101 1400 Uen B
B-11