Download ATTO Technology Diamond Storage Array V-Class Operating instructions
Transcript
6.0 Copying Drives Copying drives using the DriveCopy CLI command may be necessary on drives in the JBOD configuration. RAID Level 1 and RAID Level 10 configurations already provide mirroring of drives. DriveCopy can create a backup of a drive onto another drive sled. If one drive fails, DriveCopy may be used to copy the data off the remaining drive on the sled to another drive on another sled. Once completed, the sled containing the failed drive may be replaced. CAUTION Make sure the destination backup drive sled does not contain any important data because it will be completely overwritten by the DriveCopy command. 1 Use the DriveCopy CLI command (refer to Drive Configuration Commands on page 43) to copy a drive from the source disk to the destination disk. Parameters are the sled and drive numbers of the source and destination drives. 2 The destination drive must be offline: use the ATADiskState command to determine if the destination disk is offline. If you choose the same source and destination drive, this command performs a DriveWipe. DriveCopyHalt stops a DriveCopy operation in progress. DriveCopyResume resumes a DriveCopy operation that had been stopped. DriveCopyStatus displays the status of a DriveCopy or DriveWipe operation JBOD configurations: You may want to copy drives for backup. However, since several configurations may be present on a Diamond Storage Array, you must be confident you are accessing and overwriting the appropriate drives and volumes. configurations should not need to be backed up by copying drives since these settings already provide mirrored copies of drives. However, you may copy a drive to another drive within a RAID Level 1 or RAID Level 10 system, but the destination drive cannot contain data you want to save. RAID Level 1 and RAID Level 10 You might want to keep an entire group (LUN) free of data to use as spare drives within the array system. RAID Level 0 and RAID Level 5 systems DriveCopy may be used to coordinate the generation of a backup of an entire RAID Level 0 or RAID Level 5 LUN. 73 ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual