Download ATTO Technology Diamond Storage Array V-Class Operating instructions

Transcript
6.0 Copying Drives
Copying drives using the DriveCopy CLI command may be necessary on drives in the JBOD
configuration. RAID Level 1 and RAID Level 10 configurations already provide mirroring of drives.
DriveCopy can create a backup of a drive onto
another drive sled. If one drive fails, DriveCopy
may be used to copy the data off the remaining
drive on the sled to another drive on another sled.
Once completed, the sled containing the failed
drive may be replaced.
CAUTION
Make sure the destination backup drive
sled does not contain any important data
because it will be completely overwritten
by the DriveCopy command.
1
Use the DriveCopy CLI command (refer to Drive
Configuration Commands on page 43) to copy a
drive from the source disk to the destination
disk. Parameters are the sled and drive
numbers of the source and destination drives.
2
The destination drive must be offline: use the
ATADiskState command to determine if the
destination disk is offline. If you choose the
same source and destination drive, this
command performs a DriveWipe.
DriveCopyHalt stops a DriveCopy operation in
progress.
DriveCopyResume resumes a DriveCopy
operation that had been stopped.
DriveCopyStatus displays the status of a
DriveCopy or DriveWipe operation
JBOD configurations: You may want to copy
drives for backup. However, since several
configurations may be present on a Diamond
Storage Array, you must be confident you are
accessing and overwriting the appropriate drives
and volumes.
configurations
should not need to be backed up by copying drives
since these settings already provide mirrored
copies of drives. However, you may copy a drive
to another drive within a RAID Level 1 or RAID
Level 10 system, but the destination drive cannot
contain data you want to save.
RAID Level 1 and RAID Level 10
You might want to keep an entire group (LUN)
free of data to use as spare drives within the array
system.
RAID Level 0 and RAID Level 5 systems
DriveCopy may be used to coordinate the
generation of a backup of an entire RAID Level 0
or RAID Level 5 LUN.
73
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual