Download Extron electronics PVS 204SA Operating instructions
Transcript
Installation Rear Panel Features and Cabling 3 4 VIDEO 33 RGB 2 RGB 1A 1A 2A 2A 10 POWER I N P U T S O U T P U T S 1B 1B 12V 3A MAX 2B 2B 44 1 AMPLIFIED OUTPUTS LISTED 17TT US AUDIO/VIDEO ® STEREO ON HIGH PASS FILTER 5 AUX/MIX IN ON 6 L RS-232 MLC/IR Tx Rx IR 12V A B C DUAL MONO OFF VIDEO 4/8 Ohms APPARATUS 7 R DC VOL 10V VOL/MUTE 9 8 Figure 2-2 — Features of the PVS 204SA Switcher rear panel Power connection PRELIMINARY a DC power connector — Attach the supplied male captive screw connector to the cord of the included power supply as shown in figure 2-3. Smooth A Ridges A Power Supply Output Cord SECTION A–A Captive Screw Connector Tie Wrap 3" 16 (5 mm) Figure 2-3 — Wiring the orange captive screw power connector When all other cables have been connected, plug the captive screw connector into the 2-pole female connector (a) to connect the switcher to the 12 VDC power source. The front panel power LED ( ) lights while the PVS is receiving power. N Use only the supplied 12 V power supply for this switcher. A/V input connections video and audio inputs (“RGB”) — Each RGB input requires bBRGB the use of two twisted pair cables. Using the TP cables, connect one RGB 1A I N P U T S or two high resolution computer video and audio sources via PVT transmitters to these four RJ-45 female connectors. The PoleVault signal transmission method is specific for C PVS 204SA switchers working with PVT transmitters. DO NOT connect to an MTP system. DO NOT connect to an Ethernet/LAN or data transmission system. N The PVS 204SA can receive signals from PVT transmitters located up to 100 feet (30 m) away. The optimum distance is between 50 (15 m) and 75 feet (23 m). The minimum distance is 15 feet (5 m). 2-4 PVS 204SA Switcher • Installation 1B