Download Extron electronics PVS 204SA Operating instructions

Transcript
Installation
Rear Panel Features and Cabling
3
4
VIDEO
33
RGB
2
RGB
1A
1A
2A
2A
10
POWER
I
N
P
U
T
S
O
U
T
P
U
T
S
1B
1B
12V
3A MAX
2B
2B
44
1
AMPLIFIED OUTPUTS
LISTED 17TT
US AUDIO/VIDEO
®
STEREO
ON
HIGH
PASS
FILTER
5
AUX/MIX IN
ON
6
L
RS-232 MLC/IR
Tx Rx IR
12V
A B C
DUAL
MONO
OFF
VIDEO
4/8
Ohms
APPARATUS
7
R
DC VOL
10V
VOL/MUTE
9
8
Figure 2-2 — Features of the PVS 204SA Switcher rear panel
Power connection
PRELIMINARY
a
DC power connector — Attach the supplied male captive screw connector to
the cord of the included power supply as shown in figure 2-3.
Smooth
A
Ridges
A
Power Supply
Output Cord
SECTION A–A
Captive Screw
Connector
Tie Wrap
3"
16 (5 mm)
Figure 2-3 — Wiring the orange captive screw power connector
When all other cables have been connected, plug the captive screw connector
into the 2-pole female connector (a) to connect the switcher to the 12 VDC
power source. The front panel power LED ( ) lights while the PVS is
receiving power.
N Use only the supplied 12 V power supply for this switcher.
A/V input connections
video and audio inputs (“RGB”) — Each RGB input requires
bBRGB
the use of two twisted pair cables. Using the TP cables, connect one
RGB
1A
I
N
P
U
T
S
or two high resolution computer video and audio sources via PVT
transmitters to these four RJ-45 female connectors.
The PoleVault signal transmission method is specific for
C
PVS 204SA switchers working with PVT transmitters.
DO NOT connect to an MTP system.
DO NOT connect to an Ethernet/LAN or data transmission system.
N The PVS 204SA can receive signals from PVT transmitters located up to
100 feet (30 m) away. The optimum distance is between 50 (15 m) and
75 feet (23 m). The minimum distance is 15 feet (5 m).
2-4
PVS 204SA Switcher • Installation
1B