Download Extron electronics PVS 204SA Operating instructions
Transcript
Serial Communication The PVS 204SA switcher can be remotely set up and controlled via a host computer or other device (such as a control system) attached to the rear panel RS-232/MLC/IR port. Alternatively, the switcher can be controlled by an optional MediaLink Controller (MLC) (connected to the same port) or by an RS-232 device acting through the MLC. The control device (host) can use either Extron’s Simple Instruction Set (SIS™) commands or the Global Configurator RS-232/MLC/IR (GC2) program for Windows. For details on use and setup Tx Rx IR +12V of a system that includes a MediaLink Controller, refer to the MediaLink Controller user’s manual. A B C D E Switcher protocol: • 9600 baud • 1 stop bit • no parity • no flow control RS-232/MLC/IR connector pin assignments: (A) Transmit (Tx) (B) Receive (Rx) N Configuration can also be completed by (C) IR in connecting a 2.5 mm stereo mini cable (D) Ground ( ) (E) +12 VDC out (part # 70-335-01) to the 2.5 mm jack (port) on the front panel. This port has the same protocol as the RS-232 connector on the rear panel. PRELIMINARY 6 feet 1 5 6 9 Tip Ring 9-pin D Connection TRS Plug Pin 2 Pin 3 Pin 5 Computer's RX line Computer's TX line Computer's signal ground Tip Ring Sleeve Sleeve (Gnd) Figure 4-1 — Pin out diagram for 2.5 mm mini cable TRS plug when connecting to the front panel Config port N Firmware updates can be made only via the front panel Config port. RS-232 Programmer’s Guide Host-to-PVS communications SIS commands consist of one or more characters per field. No special characters are required to begin or end a command sequence. When the PVS switcher determines that a command is valid, it executes the command and sends a response to the host device. All responses from the switcher to the host end with a carriage return and a line feed (CR/LF = ]), which signals the end of the response character string. A string is one or more characters. PVS-initiated messages When a local event such as a front panel selection or adjustment takes place, the PVS responds by sending a message to the host. No response is required from the host. The PVS-initiated messages are listed here (underlined). © Copyright 2006, Extron Electronics, PVS 204SA, V1.xx Chn x The PVS sends the copyright messages when it first powers on. V1.xx is the firmware version number. Chn X! ] (where X! is the input number) The PVS sends this response when an input is switched. 4-2 PVS 204SA • Serial Communication