Download DigiDesign Control 24 Specifications
Transcript
Chapter 14: Automation This chapter will explain how to maximize and expand the capabilities of Pro Tools mix automation with Control|24. Recording Mix Automation Control|24 replicates Pro Tools on-screen automation features, with channel-based and session-wide automation controls. Automation Mode You can set the Automation mode for all tracks, or all selected tracks, by toggling a channel’s AUTO switch. To set the Automation mode for a track: Press the AUTO switch for any channel repeatedly to scroll through and select the desired Automation mode. ■ Channel Automation Switches The AUTO switches found in each Control|24 channel strip select the current channel automation mode (Read, Write, Trim, Latch, Touch, and Off). Current automation state is indicated using the LED labels to the right of each AUTO switch. When none of the LEDs are lit, automation is disabled for that channel. To set the Automation mode for all tracks from Control|24: Automation Section While pressing APPLY TO ALL CHANNELS or OPT(ALT)/ALL, press the AUTO switch for any channel repeatedly to select the desired Automation mode. The Automation section is located to the left of the fader bank, and consists of the MODE and ENABLE columns of six switches each, three WRITE AUTOMATION TO switches, and the AUTO SUSPEND switch. ■ To set the Automation mode for all selected tracks: 1 Select any tracks you want to affect. 2 While pressing APPLY TO ALL SELECTED CHANNELS or OPT(ALT)/ALL+SHIFT/ADD, press the AUTO switch for any selected channel repeatedly to select the desired Automation mode. AUTOMATION MODE Switches The master AUTOMATION MODE switches augment the channel AUTO switch section, for selecting channel automation mode. Chapter 14: Automation 117