Download RAD Data comm ASM-20 Specifications
Transcript
Installation and Operation Manual Appendix E IR-G.703 Interface Module Modem A Modem B IR-G.703 Module TX Data G.703 Codirectional 64 kbps Network TX Data Clock Recovery CLK Clock Out RX FIFO Clock Recovery Data Clock Recovery RX Data Timing Source FIFO RX TX Clock In EXT Clock Mode RCV Clock Mode Figure E-3. IR-G.703 EXT Timing INT/RCV Timing The INT/RCV clock is used in applications where the G.703 codirectional 64 kbps equipment connected to the modem recovers the clock signal from the modem link. This mode is used mainly when the attached equipment has a G.703 codirectional interface, but is not able to produce clock signals. The module has an 8-bit FIFO buffer to compensate for the phase delay introduced by the G.703 device. Figure E-4 illustrates the buffer connection and the required application setup. You must configure the IR-G.703 module to the INT/RCV clock if the ASM-40 modem is set to the internal or receive timing. Modem A DTE Side Modem B LINK Side G.703 Side IR-G.703 Module TX INT or RCV Clock Mode EXT, INT or RCV Clock Mode (Depending on the attached network) RX RX Clock Recovery RX Data Data CLK Clock Out FIFO Data TX Equipment with G.703 TX Data Interface Clock Recovery FIFO Clock In INT/RCV Clock Mode Figure E-4. IR-G.703 INT/RCV Timing ASM-40 Ver. 1.0 Selecting the IR-G.703 Timing E-3