Download USER MANUAL

Transcript
12
USER MANUAL
__________________________________________________________________________________________________________________
12. Start-up
Plug feeder into 230V power supply socket. When the pan is empty plug feeder
output connector into 12V socket at the right side of the scale. Autotests and
internal calibration will be performed.
Steps after start-up of the scale:
C-1
Tests of electronic scale components.
C-5
-------
0.00g
Zeroing the scale.
Ready to work.
13. Connection with computer or a printer
The scale may send data to a computer or a printer via RS232C interface.
When cooperating with a computer, the
scale sends weighing result after
initialising signal from a computer or after
pressing
key on the scale.
RxD (read)
TxD (transmit)
ground
casing
For cooperation with the scale a computer
should be equipped with software
allowing receiving data from the scale
and using it further.
AXIS offers computer programs to cooperate with scales, available on
www.axis.pl website:
- Communication – free program for sending simple commands to the scale and
receiving weighing results,