Download SVT-2 TPS Call Fowarding Device
Transcript
SVT-2 TPS Call Fowarding Device User Manual Please read this user manual prior to installing the system, and keep it well for future use. 1 About SVT-2 TPS Description: The SVT-2 TPS is a telephone converter designed for the SVT-2 systems to divert calls from the outdoor station to a telephone or mobile phone allowing a two-way communication with your guest, as well as remote unlocking the door. Features: 72 mm 90 mm • Maximum of 3 phone numbers can be programmed in one system • Requires an analog phone line connected to the system • Compatible with digital phone lines when using a converter 60 mm • Application:villa 1. Terminal Introduction 1 2 3 4 5 6 ON DIP DIP: 485 PORT: BUS(IN): BUS(OUT): TEL: PBX: 485 PORT BUS(IN) BUS(OUT) DIP switches,DIP settings refer to 3. 485 connection port,used to update the software for SVT-2 TPS. Input port,connect to power supply. Output port,connect to Monitor. Connect to the telephone. Connect to the telephone network. TEL PBX 2 Configuration: LED BUTTON Power Network Reset Signal Quality Status Transfer Recover Test * The instructions of indicator: LED indicator Power Descriptions -LED off When the SVT-2 TPS not working -LED flashes rapidly when the system error -Always on when the SVT-2 TPS work normally Network Status -Always on when the SVT-2 TPS kits work normally -LED flashes one time when the system receives the effective instruction -LED off When there is no call transfer -LEDflashesslowlywhentheSVT-2 TPSinthetransferwaitingstate Transfer -LEDflashes3timesrapidlywhentheSVT-2 TPStransferfailed -Always on when the system in the talking state * LED flashes one time when its settings are being restored to default 3 * The instructions of button: Button Reset Signal Quality Recover Test Descriptions -Press Reset button for 3 seconds,it will restart the SVT-2 TPS. -Reserved -Press Recover button for 3 seconds, its settings will be restored to default -Reserved 2. Mounting Step1: Mount the din rail to the wall with screws ; Step2: Pull down the mounting buckle,then hang the unit on din rail. Din rail Din rail Mounting Buckle 4 3. DIP Switches Setting for SVT-2 TPS Bit DIP1 Bit State Description 1 2 3 4 5 6 Set to OFF, the TPS no connection. 1 2 3 4 5 6 Set to ON, DT system connected telephone network via local switch. 1 2 3 4 5 6 Set to OFF, the TPS no connection. ON ON DIP2 ON Set to ON, DT system connected telephone network directly. 1 2 3 4 5 6 ON DIP3 Door Station speaker adjust—set to OFF, the volume is normal. 1 2 3 4 5 6 ON Door Station speaker adjust—set to ON, the volume is twice louder than normal. 1 2 3 4 5 6 ON DIP4 1 2 3 4 5 6 Door station micphone adjust—set to OFF, the volume is normal. 1 2 3 4 5 6 Door station micphone adjust—set to ON, the volume is twice louder than normal. 1 2 3 4 5 6 Reserve 1 2 3 4 5 6 Set to OFF, it shows the system is villa. 1 2 3 4 5 6 Set to ON, it shows the system is partment. ON ON DIP5 DIP6 ON ON ON Note: DIP1 and DIP2 can not be "on" state at the same time. DIP3 and DIP4 can not be "on" state at the same time. 4.Telephone Number Setting on Monitor Touch screen monitors: -Telephone Number- 1 2 3 1> _ 4 5 6 2> _ 7 8 9 3> _ 0 Don’t divert calls Divert if not answered Divert simultaneously Exit&save Exit&Unsave • Maximum 3 telephone numbers can be set,touch the telephone number frame,then input the the number by touching the digital keypad. 5 Button operation monitors: GSM configure 1) 0 2) 3) 4)Divert mode select: 2 0:Not 1:Not Answer 2:Simulateously Cancel Edit Save&Exit • Maximum 3 telephone numbers can be set,Use ▲ /▼ Button to move upward / downward to select the item,then press the MENU button to edit.Use ▲ / ▼ Button to increase / decrease the value,and use button to input next digital,use button to button to cancel the input. press the MENU button again to finish the edit operation. Note: • There are 3 types of divert modes: • 1:Don't divert calls----calls from outdoor station will not be diverted. • 2:Divert if not answered----outdoor station calls indoor monitor firstly,if nobody answer the call within 25 seconds,the call will be diverted to the telephone number you set. At this mode,the monitor will shut off immediatelly when TPS deverts sucessfully,while it won't affect the communication between TPS and outdoor station.Otherwise, the monitor can do the operation of monitoring,talking,and unlocking. • 3:Divert simutaneously----calls from outdoor station will be diverted to your telephone immediately.At this mode,the monitor won't shut off when TPS deverts sucessfully,but if the monitor answers the call at this time,TPS will quit absolutely. 6 5.Operation Instructions Note: Divert function is activated in the following instructions Item Discription Unlocking • Input 1# on your telephone or mobile phone to release the first lock • Input 2# on you telephone or mobile phone to release the second lock Hanging up • Input 9# on your telephone or mobile phone to hang off absolutely Calling next telephone number • 1:At least 2 telephone numbers must be set on monitor • 2:During communication between telephone and outdoor station,"#" button has not been input on telephone and the calling time of each group number is less than 80 seconds. Calling slave telephone • Add a letter "P" between master telephone and slave telephone.The SVT-2 TPS will call the slave telephone directly. 7 6.Wiring Basic in-out mode(for villa) CALL UNLOCK TALK/MON IN-USE CALL UNLOCK TALK/MON IN-USE CALL UNLOCK TALK/MON IN-USE to telephone to telephone network SVT-2 DPS SVT-2 PS5 SVT-2 TPS AC~ 1 23 4 5 6 ID=00 ON ON DIP6=off 1 2 Note:The SVT-2 TPS device occupies user code 15 8 Star wiring mode(for villa) Impedance switch CALL IN-USE A B C D UNLOCK TALK/MON IN-USE OFF ON DBC4S CALL UNLOCK TALK/MON CALL CALL UNLOCK UNLOCK TALK/MON TALK/MON IN-USE IN-USE CALL UNLOCK TALK/MON IN-USE IN-USE Impedance switch A B C D UNLOCK TALK/MON OFF ON SVT-2 DBC4 CALL DIP=on,off,off CALL CALL UNLOCK UNLOCK TALK/MON TALK/MON IN-USE IN-USE DIP=on,off,off 1 23 4 5 6 ON DIP6=off SVT-2 DPS SVT-2 TPS SVT-2 PS5 85~260AC ID=00 ON 1 2 Note:The TPS unit occupies user code 15 9 Basic in-out mode(for apartment) CALL UNLOCK TALK/MON IN-USE CALL UNLOCK TALK/MON IN-USE CALL UNLOCK TALK/MON IN-USE SVT-2 TPS 1 23 4 5 6 ON Code=1,DIP6=on to telephone network to telephone SVT-2 DPS SVT-2PS5 85~260AC ID=00 123456 ON 8 Basic star wiring mode(for apartment) Impedance switch CALL CALL UNLOCK UNLOCK OFF ON TALK/MON TALK/MON IN-USE CALL UNLOCK TALK/MON DIP=on,off,off IN-USE IN-USE Impedance switch CALL CALL UNLOCK UNLOCK TALK/MON TALK/MON IN-USE A B C D IN-USE OFF ON SVT-2 DBC4 CALL UNLOCK TALK/MON SVT-2 DBC4 A B C D IN-USE CALL CALL UNLOCK UNLOCK TALK/MON TALK/MON DIP=on,off,off IN-USE IN-USE 1 23 4 5 6 ON DIP6=off SVT-2 DPS SVT-2 TPS SVT-2 PS5 85~260AC ID=00 123456 ON 7.Specification Power input: Power Consumption: Working temperature: Wiring: Dimension: DC 20~28V Standby(26V):30mA;working(26V):80mA -10ºC +40ºC 2 wire,non-polarity 90(H)X72(W)X60(D)mm The design and specifications of this user manual can be changed without any notification to the user. All copyright and interpretation rights are reserved to SVT Innovations Inc.