Download MSS Controller/Microstepping Motor Drive User Manual

W I R I N G
I N P U T S
If the sensor output goes low (current flows) at the limit, select the
option “Closed.” If the output is open, (or high voltage), choose
“Open” (no current flows).
Other sensors have sourcing outputs. That means that current can
flow out of the sensor output, but not into it. In that case, wire the
sensor as shown in Figure 17.
MSS
–
2200 Ω
CW/CCW COM
5-24
Vdc
Power
+
BLU
Sourcing BLK
Hall
Effect
CW/CCW LIMIT
BRN
Figure 17 - PNP “SOURCING” HALL EFFECT CONNECTION
If the sensor output goes high (current flows) at the limit, choose the
program option “Closed.” If the output is low (open) at the limit,
select “Open.”
Caution! The current through the MSS limit switch inputs must not
exceed 20 mA. Do not use voltages higher than 24 Vdc.
14