Download EpiSensor - KMI Support WIKI

Transcript
DOCUMENT 301929, REVISION B
signal return should be connected to the negative input of the analog frontend’s differential or instrumentation amplifier and not to circuit common.
The common connection should return to the power supply through only
one path. When using a separate mains power supply for the EpiSensor, be
very careful that it does not provide a separate ground return through the
AC mains ground to the data acquisition computer. Use a star ground
configuration for your system with the EpiSensor power supply, data
acquisition system and PC all grounded at the same point.
In our experience, most noise problems with any installation are normally a
result of power grounding or cable shielding!
EpiSensor ES-U2 Specifications
42
Type
Triaxial force balance accelerometer
Dynamic range
>145 dB (RMS Noise to RMS Full Scale Clip 0.1 – 20 Hz)
Bandwidth
DC to 200 Hz
Calibration coil
Standard
Full-scale range
User-selectable at ± 0.25g, ± 0.5g, ± 1g,
± 2g or ± 4g
Output
User-selectable at: ± 2.5V and ± 10V single-ended;
± 5V, ± 20V differential
Zero adjust
Access hole for simple, efficient adjustment,
factory locked option available
Linearity
< 1000µg /g2
Hysteresis
< 0.1% of full scale
Cross-axis sensitivity
< 1% (including misalignment)
Zero point thermal drift
< 500µg / 0C
Power consumption
Quiescent current < 12 mA from ± 12V
Mounting
Dual bolt for horizontal or vertical mounting
Connection
Mil Spec Connector
Operating temperature
-200 to +700 C (00 to 1600 F)
EPISENSOR ES-U2 USER GUIDE