Download Operating Manual.vp

Cleaning & Maintenance
Finishing Unit
Cleaning of Gum/Finisher Rollers
"
It is recommended to perform this cleaning procedure once a month.
(See illustration opposite)
• Switch off and unplug the Finishing Unit.
• Remove the Gum Dryer (1).
• Remove the Gum Section Cover (2).
• Take out the roller (3).
• Release the roller bearings (4) and take out the rollers (5) and (6).
To release the roller bearings, press the locking arm as illustrated, and then pull upwards.
• Clean the rollers and bearings in hot water using a soft brush.
• Reinstall all parts in reverse order, making sure that the bearings (4) click properly
into place.
Cleaning the Finishing Unit Body
Use a cloth moistened with water then wrung well, and wipe gently to clean all
surfaces and conveyor belts.
1036
Operating Manual
3-7