Download User`s Manual
Transcript
Freescale Semiconductor, Inc. GETTING STARTED 1.4 Inserting AT60 MCUs 1.4.1 Inserting a QFP MCU The illustration below shows a Quad Flat Pack (QFP) MCU ready to be inserted in the programming adapter board: Freescale Semiconductor, Inc... 1 Open the socket case by lifting the latch. 2 Insert the MCU, matching the MCU’s Pin 1 with the socket’s Pin 1. The marked corner of the MCU identifies the location of Pin 1. (The printed number 1 on the back side of the programming adapter board corresponds to the location of the socket’s Pin 1.) Note: Motorola recommends that you use a vacuum pen or other appropriate tool to handle MCUs. Be careful to avoid bending the pins. 3 Push the socket lid down gently until it snaps shut. Pin 1 is located at the MCU’s marked corner. (The marked corner has either a recessed dot or a clipped edge.) A printed diagram in the upper left corner of the board shows the location of the QFP Pin 1. socket latch AT60 Programming Adapter Board User’s Manual For More Information On This Product, Go to: www.freescale.com 9