Download User`s Manual

Transcript
Freescale Semiconductor, Inc.
GETTING STARTED
1.4 Inserting AT60 MCUs
1.4.1 Inserting a QFP MCU
The illustration below shows a Quad Flat Pack (QFP) MCU ready to be
inserted in the programming adapter board:
Freescale Semiconductor, Inc...
1 Open the socket case by lifting the latch.
2 Insert the MCU, matching the MCU’s Pin 1 with the socket’s Pin 1. The
marked corner of the MCU identifies the location of Pin 1. (The printed
number 1 on the back side of the programming adapter board corresponds
to the location of the socket’s Pin 1.)
Note: Motorola recommends that you use a vacuum pen or other
appropriate tool to handle MCUs. Be careful to avoid
bending the pins.
3 Push the socket lid down gently until it snaps shut.
Pin 1 is located at the MCU’s marked
corner. (The marked corner has either a
recessed dot or a clipped edge.)
A printed diagram in the
upper left corner of the
board shows the location
of the QFP Pin 1.
socket latch
AT60 Programming Adapter Board User’s
Manual
For More
Information On This Product,
Go to: www.freescale.com
9