1
Download Concept 2.6 User Manual
Transcript
PLC configuration Configure Ethernet Introduction Precondition An Ethernet bus system can be configured within the following PLC families: l Quantum l Atrium l Momentum In order to connect to the Ethernet bus system, a PCI network card must be available in the host computer. Afterwards the Ethernet interface needs to be parameterized and the drivers that are provided on CD need to be installed (Configure Ethernet, p. 952 ). After the Ethernet module has been slotted into the central backplane, the internet address, subnet mask, gateway and frame type can be allocated by the network administrator. Configuration with Quantum 33002204 The procedure for Ethernet configuration in Concept is as follows: Step Action 1 In the PLC Configuration window, open the Select Extensions dialog. 2 Enter the number of Ethernet modules (NOE) in the text boxes. Response: The modules then appear in the list box in the I/O Module Selection dialog and can be inserted into the I/O map. 3 In the PLC Configuration window, open the Ethernet I/O Scannerdialog, in which you enter the information from the network administrator (Internet address, subnet mask, gateway, frame type). 4 In the Online main menu, open the Connect to PLC dialog (menu command Connect...). 5 In the Protocol Type list box, select the option TCP/IP, and in the IP address or DNS Hostname text box, enter the address of the TCP/IP card. 6 After programming, in the Online main menu, open the Load into PLC dialog (menu command Load...), and click on the Load command button. Response: A message appears, asking whether you would like to start the PLC. 7 Before you confirm the message with the Yes command button, the display "link" must appear on the Ethernet module. 141
