Download Software Manual WinIQSIM

CDMA2000
WinIQSIM
Data
Selection of one of the four data sources Data 0, Data 1, Data 2 or PRBS.
For the definition of data sources see section 7.2.
State
With this switch it can be determined whether the code channel is to be contained in the scenario or not.
The State buttons of active channels are shown in green. Thus active channels can be seen at a glance.
12.2.2.6.3 Reset BS Table
The reset button is used to reset the channel table of the mobile station to defined settings. The
parameters described in section 12.2.2.5.1, Common Base Station Settings, are not affected. The reset
values are shown in the following table.
Table 12-12
Reset values of BS table
Parameters of code channels
Reset value
Frame length
Dep. on channel type, 20 ms if possible,
otherwise lowest possible frame length.
Data rate
Dep. on channel type, 9.6 kbps if possible,
otherwise lowest possible data rate
Long-code mask
0 for all channels
Power
0 dB for all channels
Data source
PRBS for all channels
State
Off for all channels
12.2.2.6.4 Channel Graph
This graph shows all active channels at a glance.
Fig. 12-32
Channel graph
Special channels and traffic channels are coloured as described in section 0 The channel power can be
seen from the length of the line. The channel graph can be displayed simultaneously with the other
windows. Thus, modifications in the channel table having an effect on the channel graph can be seen at
a glance.
The Mobile Station Configuration panel is quit with the OK button as usual. When the Cancel button is
pressed, the window is cleared and all new settings are discarded.
1013.1642.02
12-38
E-1