Download Part Editor - Right Click Options

eCabinet Systems Version 5.2
Autofill - This duplicates the highlighted cabinet, by adding exact copies of it to both the left and
the right, until the entire wall is filled.
Cabinet End - This opens a dialog where you can define and place applied ends on a cabinet.
Apply to side - This selects appropriate side of cabinet.
Scribe - This area only applies to face frame cabinets, and is used to adjust the scribe
or the amount that the face frame stile extends past the outside edge of the cabinet.
Inset Values - These settings here are used to make the applied end either larger or
smaller than it would normally be. If you specify an inset for one edge, top, bottom,
front or back, the corresponding edge of the applied end will be inset, or made
smaller, than the original size. If you specify a negative inset, that edge is made larger
or extended.
Applied End - This opens either the Door/Drawer Editor, where you can select a
door and/or drawer to apply to the cabinet end, a Defined Material selection, to
apply a different material to the end, or to remove any existing Applied End.
Duplicate Left - This duplicates the highlighted cabinet by adding exact copies of it to the left,
until the entire wall to the left of the selected cabinet is filled.
Duplicate Right - This duplicates the highlighted cabinet by adding exact copies of it to the right,
until the entire wall to the right of the selected cabinet is filled.
Edit Cabinet - This takes the highlighted cabinet to the Cabinet/Assembly Editor where it can
be modified.
Expand to Fill - This expands the selected cabinet width to completely fill the space that it
occupies.
Resize/Equalize - If a single cabinet is selected, this opens a dialog that allows you to resize it. If
two or more adjacent cabinets are selected, or if a base and corresponding upper cabinet are
selected, it makes them equal in width.
- 111 -
Thermwood Corporation