Download Part Editor - Right Click Options

eCabinet Systems Version 5.2
The dimension box for Cathedral doors contains two additional fields. Top Flat specifies a flat area at
the top of the curved arch, while Minor Rad % specifies the radius joining the side fats to the main arch
as a percent of the radius of the main arch. If this radius is set to zero, the Cathedral door becomes the
same as an Arch door. This is useful if you want an Arch door with a top flat.
These settings allow the development of almost any Arch and Cathedral geometry. You may need to
experiment with the settings to develop a full understanding of how they interact and function. To create
a new door, input the name of the new door in the Door Name box and press Reset View. A dialog will
tell you that this door is not currently saved and will ask if you want to create a new door with the new
name. Press OK and the new door is created and saved. If you were displaying another door, all the
settings for that door will be used on the new door. If you want to start with blank settings, press the
Clear button. At this point, you can input the new door name and input the appropriate settings for the
new door design. Once complete, be sure to Save the design before closing the dialog.
Note: The Drawer Fronts have the same options, with the exception that there are no Arch or
Cathedral selections.
- 331 -
Thermwood Corporation