Download User Manual

Gill Instruments Ltd
_____________________________________________________________________________________________________________
Example Summary of MaxiMet Device Settings (GMX600 shown):SETTINGS ARE AS FOLLOWS:
PROTOCOL : GILL
COMMS : RS232
(BAUD) : 19200
NODE : Q
OUTFREQ : 1HZ
MSGMODE : CONT
ASCTERM : CRLF
ECHO : ON
ALIGN : 0
SENSOR WIND : ON
UNITS WIND : MS
NODIR : 0.00
AVGSHORT : 60
AVGLONG : 10
SENSOR COMPASS : ON
SENSOR TEMP : ON
UNITS TEMP : C
SENSOR DEWPOINT : ON
UNITS DEWPOINT : C
SENSOR PRESS : ON
UNITS PRESS : HPA
HASL : +00000.00
HASTN : +00000.00
SENSOR RH : ON
UNITS RH : %
SENSOR PRECIP : ON
UNITS PRECIP : MM
ARPRECIP : ON
REPORT : NODE DIR SPEED CDIR PRESS RH TEMP DEWPOINT PRECIPT PRECIPI TIME VOLT STATUS
POWER : 0
TIME :2015-03-23T13:36:09
PUPMSG STATUS : ON
PUPMSG REPORT : ON
PUPMSG UNITS : ON
MODBUS : RTU
MODADDR : 1
DATABITS : 8
STOPBITS : 1
PARITY : NONE
MODTERM : 10
MODICT : 1000
Note changes to BAUD and COMMS settings will take place after next power-up.
Click on the Close button to continue to the MetSet set up screen.
________________________________________________________________________________________________
MaxiMet
Page 42
Issue 4
Doc. No. 1957-PS-001
August 2015