Download User Manual

Gill Instruments Ltd
_____________________________________________________________________________________________________________
7.2.2 Scanning for Devices
To set up communicate between MetView and a connected MaxiMet:
Click on the Scan button to search the available COM ports for connected MaxiMet units.
If Connect to first device found has been selected then MetView will automatically connect to
the MaxiMet on COM Port 10 (connects to lowest numbers first) and open the MaxiMet data view
screen showing all of the MaxiMet parameters that have been enabled as outputs.
If Connect to first device found is deselected then click on the Scan button.
MetView will then allow the required MaxiMet connection to be made using the blue background
highlighted drop down menu.
Select Connect to go to the Data view screen.
To select the other MaxiMet then I the Data view screen select the Disconnect button and use the
drop down menu below to select and connect to the new MaxiMet.
________________________________________________________________________________________________
MaxiMet
Page 80
Issue 4
Doc. No. 1957-PS-001
August 2015