Download User Manual

Gill Instruments Ltd
_____________________________________________________________________________________________________________
GMX400 Factory Default Data String
: NODE PRESS RH TEMP DEWPOINT TOTAL PRECIP PRECIP INTENSITY TIME VOLT
STATUS.
Q,1015.3,041,+022.0,+008.5,00000.2,000.2,2015-06-05T10:19:30.8,+05.1,0000, 36
Where
Q
1015.3
041
+022.0
+008.5
0000.2
000.2
2015-06-05
T10:19:30.8
+05.1
0000
36
STX
Node Letter
Pressure
Relative Humidity
Temperature
Dewpoint
Precipitation Total
Precipitation Intensity
Date
Time
Supply Voltage
Status
ETX
Checksum
NOTES:
<STX> is the Start of String character (ASCII value 2).
<ETX> is the End of String character (ASCII value 3).
Checksum, the 2 digit Hex Checksum sum figure is calculated from the Exclusive OR of the bytes
between (and not including) the STX and ETX characters
MetSet Default Settings
REPORT : PRESS RH TEMP DEWPOINT TOTAL PRECIP PRECIP INTENSITY TIME VOLT
STATUS
PROTOCOL : GILL
SENSOR TEMP : ON
POWER : 0
COMMS : RS232
UNITS TEMP : C
TIME : 2015-06-05T11:04:54
BAUD : 19200
SENSOR DEWPOINT : ON
AUTOTIME : ON
NODE : Q
UNITS DEWPOINT : C
TZOFFSET : +00.00
OUTFREQ : 1HZ
SENSOR PRESS : ON
PUPMSG STATUS : ON
MSGMODE : CONT
UNITS PRESS : HPA
PUPMSG REPORT : ON
ASCTERM : CRLF
HASL : +00000.00
PUPMSG UNITS : ON
ECHO : ON
HASTN : +00000.00
MODBUS : RTU
ALIGN : 0
SENSOR RH : ON
MODADDR : 1
UNITS RH : %
DATABITS : 8
PRECIPITATION SENSOR : ON STOPBITS : 1
PRECIPITATION UNITS : MM
PARITY : NONE
MODTERM : 10
MODICT : 1000
________________________________________________________________________________________________
MaxiMet
Page 37
Issue 4
Doc. No. 1957-PS-001
August 2015