Download LabVIEW Control Design User Manual
Transcript
Chapter 6 Working with Delay Information This equation shows that the Laplace transform of a function delayed td units of time in the past is identical to the product of the Laplace transform of the original function and the factor e – std , where s is the Laplace variable. Thus, you can incorporate delay into h(t) by multiplying H(s) by the delay factor e – std . For example, consider the continuous SISO transfer function H(s) with output Y(s) and input U(s). Because e –std represents the delay factor, H ( s )e – std defines a system that has a transport delay. Y(s) H ( s )e – std = ----------U(s) You also can represent the delay as an input delay or output delay. Applying the delay factor e – std to the input U(s) results in an input delay as shown in the following equation: Y( s) H ( s ) = --------------------– st d e U(s) Conversely, applying the delay factor to the output Y(s) results in an output delay shown in the following equation: e std Y ( s ) H ( s ) = -----------------U(s) Figure 6-1 shows the mathematical representation of transport, input, and output delay factors for a continuous system. H(s)e–std [u(t)] = U(s) [u(t – td)] = U(s)e–std H(s) U(s) H(s) [y(t)] = Y(s) Y(s) [y(t + td)] = Y(s)estd : Laplace Transform Figure 6-1. Mathematical Representation of Transport, Input, and Output Delay for a Continuous System Control Design User Manual 6-4 ni.com