Download LabVIEW Control Design User Manual

Transcript
Chapter 6
Working with Delay Information
This equation shows that the Laplace transform of a function delayed td
units of time in the past is identical to the product of the Laplace transform
of the original function and the factor e – std , where s is the Laplace variable.
Thus, you can incorporate delay into h(t) by multiplying H(s) by the delay
factor e – std .
For example, consider the continuous SISO transfer function H(s) with
output Y(s) and input U(s). Because e –std represents the delay factor,
H ( s )e – std defines a system that has a transport delay.
Y(s)
H ( s )e – std = ----------U(s)
You also can represent the delay as an input delay or output delay. Applying
the delay factor e – std to the input U(s) results in an input delay as shown in
the following equation:
Y( s)
H ( s ) = --------------------– st d
e U(s)
Conversely, applying the delay factor to the output Y(s) results in an output
delay shown in the following equation:
e std Y ( s )
H ( s ) = -----------------U(s)
Figure 6-1 shows the mathematical representation of transport, input, and
output delay factors for a continuous system.
H(s)e–std
[u(t)] = U(s)
[u(t – td)] = U(s)e–std
H(s)
U(s)
H(s)
[y(t)] = Y(s)
Y(s)
[y(t + td)] = Y(s)estd
: Laplace Transform
Figure 6-1. Mathematical Representation of Transport, Input, and
Output Delay for a Continuous System
Control Design User Manual
6-4
ni.com