Download Installation and Configuration Guide
Transcript
SigTEL EVC System Installation and Configuration Guide 18. Component Specifications Power Supplies Mains and batteries must be connected to the CCU-16 and each SCU-16. Mains must be permanently connected and local wiring regulations must be followed. No other power connections are required. External cabling Outstation lines 2-core 1.0 mm2 or 1.5 mm2 enhanced fire-rated cable, up to 1 km per line. CCU to SCU, SCU to SCU Two 4-core 1.0 mm2 or 1.5 mm2 enhanced fire-rated, max 800 metres between CCU and last SCU. Max 200 metres between individual units. ECU to CCU Two 4-core 1.0 mm2 or 1.5 mm2 enhanced fire-rated cable, up to 200 metres. Do not use a larger multicore as audio and data must be separately screened. CCU-16 Master control unit and SCU-16 Slave control unit Base dimensions 412 mm W x 250 mm H x 80 mm D Lid dimensions 435 mm W x 269 mm H x 11 mm D Weight, unpacked 3.1 Kg, packed 4.0 Kg Power supply Mains supply 230 VAC 50/60 Hz Internal supply 27.6 VDC Output current 1 amp max Supply monitored for failure Yes Batteries monitored for failure Yes Quiescent current <30 mA Max current < 50 mA Fuses Mains fuse 1 A (T) 20 mm HRC Battery fuse 1 A (F) 20 mm Batteries, per CCU-16 and SCU-16 Two 12 Volt 7 Ah Each CCU & SCU needs a separate mains supply Line specification Max Number of lines per CCU / SCU-16 16 Number of outstations per line 1 Lines monitored for open circuit Yes Lines monitored for short circuit Yes Lines monitored for earth fault Yes SigTEL Emergency Voice Communication System Approved Document No. DCP0001483 Rev 3 Page 29 of 32