Download Final Report - Senior Design
Transcript
To maximize efficiency we used the following equations to calculate ripple current and ripple voltage. Ripple Current: Ripple Voltage: In research on the type of solar panels that would be provided or packaged with our system, we needed to choose a ripple current that would leave our charger in Constant Current Mode (CCM) for almost all charging situations. Our design requires the converter to operate in CCM and not in Discontinuous Current Mode (DCM) because of the losses that our system would see during DCM mode. For this system, a design was chosen with a current ripple of less than 10% of our full charging current (load current). For a current ripple of less than 500mA, we found the closest popular inductor value to be 47uH. Therefore, the ripple current equation with the values is the following; Using this ripple current, we can then calculate the output voltage ripple. We wanted to minimize our output ripple voltage to assure that there could be no inaccurate readings from the voltage feedback. For this, an output ripple voltage of 2-3mV was desired without the ESR considerations. A common 220uF capacitor size was chosen to provide the desired voltage ripple. With these values chosen and optimized for our design we assure that we can provide maximum charging efficiency. Other efficiency considerations in the design include the input N-FET to the buck converter acting as a diode to prevent feedback current when no load is present. 16