1
Download Mikrotik
Transcript
Manual:MPLS 1 Manual:MPLS Sub Categories List of reference sub-pages Case studies List of examples • Interface General General • • • • • • • vpls traffic-eng MPLS • • MPLS Overview and RouterOS MPLS Implementation Status EXP bit behaviour L2MTU Layer2 VPN ldp traffic-eng • • • • Layer2 VPN • P2P L2VPN to Juniper router Layer3 VPN LDP and LDP based VPLS BGP based VPLS Cisco style VPLS VPLS Control Word Layer3 VPN • • • MPLS over PPPoE • • • • A complete Layer-3 MPLS VPN example VRF Route Leaking Internet access from VRF Internet access from VRF with NAT Traffic Engineering Virtual Routing and Forwarding (VRF) OSPF as PE-CE routing protocol EBGP as PE-CE routing protocol • • Simple TE configuration TE tunnels for VPLS Traffic Engineering • • TE Tunnels TE Tunnel Bandwidth Control Summary MikroTik RouterOS [1] supports MPLS. All MikroTik RouterBOARD [2] hardware products support MPLS. General Porperties Property Description dynamic-label-range (range of integer[16..1048575]; Default: 16-1048575) Range of Label numbers used for dynamic allocation. First 16 labels are reserved for special purposes (as defined in RFC). If you intend to configure labels statically then adjust dynamic default range not to include numbers that will be used in static configuration. propagate-ttl (yes | no; Default: yes) Whether to copy TTL values from IP header to MPLS header. If this option is set to no then hops inside MPLS cloud will be invisible from traceroutes. Forwarding Table Sub-menu: /mpls forwarding-table Entries in this sub-menu shows label bindings for specific routes that will be used in MPLS label switching. Properties in this menu are read-only
