Download SmartRack User Manual

Transcript
Please note the following maximum cable sizes:
Earth and Neutral bars:
2 . 5 k W Phase terminals:
5kW Phase terminals:
10kW Phase terminals:
10 x 10mm2, 3 x 16mm2
4mm2
6mm2
3 5m m2
It is occasionally necessary to use larger cable sizes on the 2.5kW and
5kW dimmers, and an adapter kit is available, with 10mm2 and 16mm2
DIN terminals for oversized cables. See section 10.7 for part numbers.
Note that bootlace ferrules are required to be fitted to the earth and neutral wires if stranded cable is used.
a)
Terminate load earth wires into the earth busbar on the left side of the
power assembly. Recommended tightening torque 1.5Nm (2.5mm2
cable) to 2 N m (10mm2 cable).
Terminating load wiring.
Note hat numbering is
always from left to right, ie:
E a h 1-12, Neutml I-12,
Phase 1- 12. f i e same rule
applies to 3x 1Ok W and
6xSkW Power Assemblies.
Tip:
It's easier to fit the
bottom Power
Assembly first,
terminate the load
wirin5 then fit the
middle Power
sembly, and so on.
page 23