Download ComBricks User Manual - Streamline Process Management

Transcript
COMbricks – User Manual
10.5 DP/DP coupling or Gateway mode
A unique feature of the PBS-001 is that it can be used as a DP/DP coupler for up to 10 networks, where
each network can have different bus parameters and baud rates. It connects the networks on an I/O level,
where you can decide how many bytes need to be transferred. For each network a PBS-001 is needed. So
if you wish to connect 2 networks, you need 2 PBS-001 modules in one COMbricks set.
A typical COMbricks configuration for a DP/DP setup may look like Fig. 64:
Fig. 64 - COMbricks configuration screenshot
of the web server
Fig. 65 - Schematic representation
of the gateway
Slot 1 belongs to Network 1. Slot 2 is connected to Network 2. These networks can now be coupled via the
configuration tools of each master. For example, if you want to transfer 4 bytes, the setup for the
configuration tool of network 1 will look as follows:
Fig. 66 - Configuration for Network 1
The first slot is used for the PBS-001 module. The next slot is used for anther PBS-001 module, but a
gateway module must be selected because the PBS-001 itself does not have any I/O.
_______________________________________________
Version 5.4.0 – June 2014
COMbricks-User-Manual1-EN.docx
Page 103 / 184
© PROCENTEC 2014 - Copyright - all rights reserved