Download Code 39 Set Length 1 - SC

Reading Parameters
Enter/Exit Programming Mode
Stand Mode Illumination Off Time
Specifies the amount of time reader illumination stays off after pulling the trigger when in Stand
Mode. The configurable range is 01 to 32 by 01 in increments of 500ms (500ms to 16 seconds). See page 255 in “References” for a description of this feature.
$CSNTM
Select Stand Mode Time Setting
DEFAULT
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE bar code above, then the bar code at
left followed by the digits from the Alphanumeric characters in Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
bar code again.
04 = 2 Seconds
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state once the state is
entered. The range for this setting is from 1 to 255 seconds in 1-second increments. See
page 256 in “References” for further description of this feature.
$CSNET03(CR)
Scanning Active Time = 3 seconds
$CSNET05(CR)
DEFAULT
Scanning Active Time = 5 seconds
$CSNET08(CR)
Scanning Active Time = 8 seconds
Product Reference Guide
79