Download Manual - Advantage Controls
Transcript
B. Wiring The Little Dipper is provided with a four (4) conductor cable to power the sensor and send the 4-20mA output. WARNING: Improper wiring may damage sensor and signal receiving equipment. The power ground ! (Black & Red Wires) and the 4-20 mA return (Orange/Green & Brown/White Wires) are not common. These wires should not be connected to the same point). Red Wire = +10-30 Vdc Power Orange/Green Wires = + 4-20mA output Black Wire = Power Ground Brown/White Wires = Return 4-20mA output C. Motherboard Connections MegaTron Mother Board Wiring for Sys 1 Comm, Little Dipper Card Slots Program / Memory Card Connection Aux. Meter Inputs MegaTron MegaTron SS Processor Note: Refer to full manual for additional information +5 +5 Key Pad Ribbon Cable Connection Relay Card Outputs 16-20 11-15 6-10 Incoming Power RED (+) 12 VDC Input 1 Input 1 + WHITE (-4-20) GREEN (+4-20) LED -12 +12 +5 +5 Flow Switch ORP ORP pH pH Ground Drum Level 5 Drum Level 4 Drum Level 3 Ground Drum Level 2 Drum Level 1 Water Meter Ground Water Meter 2 Signal Water Meter 1 Signal +5 VDC RED (+) 12 VDC Input 3 + Input 3 Input 2 + Input 2 Input 1 + Input 1 - BROWN BLACK Conductivity Temperature Display Ribbon Cable Connection GREEN (+4-20) WHITE (-4-20) RED Note: Use 22 AWG (.76 mm) twisted pair shielded wire for all of these low voltage signal connections. Processor Key Pad Ribbon Cable Connection BLACK (ground) BLACK Ground Ground Ground W W W R All 3 Communications Program / Memory Card Connection Card Connection TERMINAL BLOCK RED Signal Aux Flow 3 Signal Aux Flow 2 Signal Aux Flow 1 Aux Flow +5 vdc B B GREEN -> ORANGE WHITE - > BROWN BLACK - > BLACK RED -> RED Aux Flow Aux Flow BROWN RED BLACK ORANGE Connection Codes: Red Black Green White Red Black Black Red MegaTron SS Motherboard ORANGE 1-5 BLACK (ground) BLACK RED -12 +12 Key Pad Ribbon Cable Connection TERMINAL BLOCK MegaTron SS 4-20mA Input 5 LED Cable Relay Card Ribbon