Download SIMATIC HMI HMI Device TP 177A, TP 177B, OP

Appendix
A.2 System Alarms
Number
Effect/cause
Remedy
290063
This occurs with the system function
"ExportDataRecords" when the parameter
"Overwrite" is set to No.
An attempt has been made to save a recipe under
a file name which already exists.
The export is canceled.
Check the "ExportDataRecords" system function.
290064
Message reporting that the deletion of data records
has started.
—
290065
Message reporting that the deletion of data records
has successfully completed.
—
290066
Confirmation request before deleting data records.
—
290068
Security request to confirm if all data records in the
recipe should be deleted.
—
290069
Security request to confirm if all data records in the
recipe should be deleted.
—
290070
The data record specified is not in the import file.
Check the source of the data record number or data
record name (constant or tag value).
290071
During the editing of data record values, a value
was entered which exceeded the low limit of the
recipe tag.
The entry is discarded.
Enter a value within the limits of the recipe tag.
290072
When editing data record values, a value was
entered which exceeds the high limit of the
recipe tag.
The entry is discarded.
Enter a value within the limits of the recipe tag.
290073
An action (e.g. saving a data record) failed due to
an unknown error.
The error corresponds to the status alarm
IDS_OUT_CMD_EXE_ERR in the large
recipe view.
—
290074
While saving, it was detected that a data record
with the specified number already exists but under
another name.
Overwrite the data record, change the data record
number or cancel the action.
290075
A data record with this name already exists.
The data record is not saved.
Please select a different data record name.
300000
Faulty configuration of process monitoring
(e.g. using PDiag or S7-Graph): More alarms are
queued than specified in the specifications of the
CPU. No further ALARM_S alarms can be
managed by the PLC and reported to the
HMI devices.
Change the controller configuration.
300001
ALARM_S is not registered on this controller.
Select a controller that supports the ALARM_S service.
310000
An attempt is being made to print too many reports
in parallel.
Only one log file can be output to the printer at a
given time; the print job is therefore rejected.
Wait until the previous active log was printed.
Repeat the print job if necessary.
310001
An error occurred on triggering the printer. The
report is either not printed or printed with errors.
Evaluate the additional system alarms related to this
alarm.
Repeat the print job if necessary.
360
TP 177A, TP 177B, OP 177B (WinCC flexible)
Operating Instructions, 08/2008, 6AV6691-1DG01-0AB1