Download Manual - Process Controls

MULTI-PARAMETER TRANSMITTER USER’S MANUAL
Flow - Utilities Menu - Meter Selection 7.3
TOTAL
0
RUN MODE
The Meter Selection menu is used to select the meter type that the
controller is configured for, either pH, ORP, Conductivity or FLow.
Once selected, the controller will initialize itself for the selected meter's
functionality and move to run mode.
DOWN
CALIBRATION
DOWN
UTILITIES
MANUAL TEST MODE
Press the
key to initialize the
controller as a pH meter.
DOWN
METER SELECTION
PH
ORP
PH
INITIALIZE?
DOWN
Y N
DOWN
Press the
key to initialize the
controller as an ORP meter
O RP
CONDUCTIVITY
ORP
INITIALIZE?
DOWN
To reset the controller back to all
the factory default values, reselect
the current meter type
Y N
DOWN
Press the
key to initialize the
controller as a Conductivity meter
C ONDUCTIVITY
FLOW
CONDUCTIVITY
INITIALIZE?
DOWN
Y N
DOWN
Press the
key to initialize the
controller as a Flow meter
F LOW
EXIT
FLOW
INITIALIZE?
DOWN
Y N
DOWN
Press the
key to Exit and
return to the Utilities menu
E XIT
PH
If you do not wish to initialize to this
type of meter after all, then press DOWN
key to return back to the Meter
Selection menu
DOWN
If you do wish to initialize to this
type of meter, press the
key to highlight the Y character
Then press DOWN
The controller will initialize itself for a
specific meter
FLOW
INITIALIZE?
Y N
DOWN
NOTE
PRESS THE UP AND DOWN KEYS
TOGETHER TO GO IMMEDIATELY BACK TO
RUN MODE
Flow - Utilities Menu - Meter Selection 7.3
Page 67