Download USER`S MANUAL - Security Point

Transcript
1DOOR ACCESS CONTROLLER
9.4.1 VERSION CHECK
VERSION
iCON100:V4.0
? . The version of the controller’s firmware is displayed on the LCD.
Press <4> or <6> key to look for other menus of setup menu F4.
9.4.2 SRAM TEST
SRAM
TEST
Memory fail!! 00
RAM testing...
RAM test pass!!!
Press any key...
? . To test the SRAM memory, press <ENT> key.
? . If the SRAM has problems, LCD will show the memory block
number with Memory fail message. In this case, you have to
contact technical support. Press any key to return to the setup
menu.
? . If the SRAM is working properly then LCD will show RAM test
pass message. Press any key to return to the setup menu.
9.4.3 OUTPUTS TEST
OUTPUT TEST
Enter any key
<ENT>
Relay 1 test
(Activated two times)
This test is applicable to
Relay1 and LED.
Relay 2 test
(Activated two times)
This test is applicable to
Relay2 and LED.
TTL Output 1 test
(Activated two times)
This test is applicable to
TTL1. (0V - 5V)
TTL Output 2 test
(Activated two times)
This test is applicable to
TTL2. (0V - 5V)
Buzzer Output test
(Activated two times)
This test is applicable to
Buzzer.
Output test end
51
20030516
Manual
User’s