Download USER MANUAL

12. ADVANCED FUNCTIONS
12.4 Embedded Web Server: functions
The “Printer Settings” section is a restricted one. To enter the section, it is required the identification of the user and
password. With the tools of this section, it is possible to set up the same parameters of the printer that are configurable in the printer’s Set-up mode (see par. 5.5).
The following figure shows the page for the “EMAIL SETUP” tool. It is divided into 4 areas:
1.
SECTIONS:
The web server has three sections listed within each web page. These sections
are: Device Info, Printer Settings, Printer Support.
2.
CURRENT PAGE
Reports section currently displayed.
3.
TOOLS
Lists the tools available within the chosen section.
4.
EMAIL SETUP
Displays the fields available to configure the automatically delivery of service
email in order to inform the user when a change occurs to operating status of the
printer. It is possible to select the events to enable the sending of the email
1
'(9,&(,1)2Ň35,17(56(77,1*6Ň35,17(56833257
Web Site
ER
< PRINTER >
>
INT
Ticket Printer
R
<P
2
3
PRINTER SETTINGS
E-Mail Service Settings
Printer Setup
Network Setup
SMTP Server Address
SMTP Server Port
smtp.xxxxxx.it
25
Email Setup
E-mail To
[email protected]
Email Log
E-mail From
E-mail Subject
<PRINTER>@xxxxxxx.it
test
Testo libero
E-mail Message
Include Printer Status
when Paper End is detected
when Near Paper End is detected
on Printer Power On
when Near Paper End is detected
on Cut
on LF key pressed
on FF key pressed
Send e-mail event
on S1 key pressed
on S2 key pressed
on Cut error
on Paper Jam
on Notch Align error
on Autoload
on Head Over Temperature error
on Supply Voltage error
4
Reset e-mail settings...
User manual
Save e-mail settings
KPM302-KPM303 109