Download User`s Manual

operation2.book
Page 19
Wednesday, January 7, 2004
10:04 AM
Section 2
PREPARATION FOR MEASUREMENT
Through-beam Type Sensor Head
„ Installation
Fix the through-beam type sensor head with M3 screws. The screws must be tightened
with a torque of 0.3N•m or lower.
ZX-LT001/LT005
ZX-LT001/LT005 Mounting dimensional drawing (same for both
9±0.1
(Unit: mm)
2-M3
ZX-LT010
ZX-LT010 Mounting dimensional drawing (same for both emitter and
14±0.1
receiver) (Unit: mm)
Section 2 Installing Sensor Heads
emitter and receiver)
2-M3
Make sure that the emitter and receiver are mounted in the correct direction as shown below.
Mounting them in the wrong direction will hinder correct measurements.
Mounting hole
Receiver
Mounting hole
Emitter
ZX-L-N
User’s Manual
19