Download E-625 Piezo Servo Controller

8 Adjustment of Internal Settings
Synchronizing the Sensors
Figure 10: Settings for the master/slave switch
1. Select an E-625 as the sensor master and check the position of the
master/slave switch. The master position (see top figure) is the default setting.
2. If the master/slave switch on the selected sensor master is not in the master
position, use the trimmer adjustment tool to turn it to the master position.
3. Set all other E-625 to sensor slave. To do this, turn the master/slave switches
to the slave position (see top figure) using the trimmer adjustment tool.
4. Close the cases.
5. Make sure that all devices have the synchronization lines (pin 7 and 8 on the
Network socket) and at least one ground wire (pin 1, 2 or 5 on the Network
socket) connected to the corresponding wire, (for details see pin assignment
of the E-625.CN network cable (p. 85)).
E-625 Piezo Servo Controller
PZ166E
Version: 1.7.0
51