Download DT-100
Transcript
If a DT100IR with selected in-use locomotives is disconnected from LocoNet for more than the system purge time (about 200 seconds), the Command Station will purge these in-use locomotives to the common state so that other throttles can access these locomotives. If the original DT100IR is reconnected after a purge of its last in-use locomotives, it will recognize this. If the previously in-use locomotives that are now common locomotives have not been selected by other LocoNet throttles, the original DT100IR will automatically re-log on to these purged locomotives. If the this is not the case, simply reselect the purged locomotives by pressing the key for the appropriate throttle, i.e., the DT100IR throttles still remember the locomotive that was last selected. The SET operation will reactivate the throttle & make the locomotive in-use in exactly the state the system remembers it. The designation of locomotives as in-use or common ensures orderly sharing of locomotives on the layout & increases the system's ability to run more locomotives at a time 12.1 Forcing A Selection, or "Stealing" A "Lost" Locomotive You won't be able to select a locomotive to a throttle if the DCS100 realizes it is already "in-use." It is possible to override this interlock & force the DT100IR to select an already "in-use" loco. This is called locomotive "stealing" & can result in two throttles logged onto a single locomotive. Because of this multiple-throttle interaction you should be careful when you use stealing. It is useful to use to gain control of "lost" locomotive before the system actually purges it. To Steal a Locomotive Using a DT100IR: 1. Use either throttle knob to browse to the address of the DCC locomotive you want to steal. In 2 digit address mode the DCC locomotive status digits on the right will typically show "3x" indicating this address is "inuse" & not normally selectable. 2. If you are in a 4 digit address display mode the Loco status will flash up "St:3y" after your browsing address has been stable for at least a second. 3. Before you time-out of "browse" mode & while you still have the loco you want to steal showing in the display, press "SEL/SET" if the locomotive is not available the display will show "SE:L". 4. Now disconnect the DT100IR from LocoNet. The display should immediately go blank . or ) 5. Press & hold the direction arrow for the throttle side (either you were using in step (1) & plug the DT100IR back into LocoNet. 52