Download DT-100

Transcript
If a DT100IR with selected in-use locomotives is disconnected from LocoNet
for more than the system purge time (about 200 seconds), the Command
Station will purge these in-use locomotives to the common state so that other
throttles can access these locomotives. If the original DT100IR is
reconnected after a purge of its last in-use locomotives, it will recognize this.
If the previously in-use locomotives that are now common locomotives have
not been selected by other LocoNet throttles, the original DT100IR will
automatically re-log on to these purged locomotives.
If the this is not the case, simply reselect the purged locomotives by pressing
the
key for the appropriate throttle, i.e., the DT100IR throttles still
remember the locomotive that was last selected. The SET operation will
reactivate the throttle & make the locomotive in-use in exactly the state the
system remembers it. The designation of locomotives as in-use or common
ensures orderly sharing of locomotives on the layout & increases the system's
ability to run more locomotives at a time
12.1 Forcing A Selection, or "Stealing" A "Lost"
Locomotive
You won't be able to select a locomotive to a throttle if the DCS100 realizes it
is already "in-use." It is possible to override this interlock & force the
DT100IR to select an already "in-use" loco. This is called locomotive
"stealing" & can result in two throttles logged onto a single locomotive.
Because of this multiple-throttle interaction you should be careful when you
use stealing. It is useful to use to gain control of "lost" locomotive before the
system actually purges it.
To Steal a Locomotive Using a DT100IR:
1. Use either throttle knob to browse to the address of the DCC locomotive
you want to steal. In 2 digit address mode the DCC locomotive status
digits on the right will typically show "3x" indicating this address is "inuse" & not normally selectable.
2. If you are in a 4 digit address display mode the Loco status will flash up
"St:3y" after your browsing address has been stable for at least a second.
3. Before you time-out of "browse" mode & while you still have the loco
you want to steal showing in the display, press "SEL/SET" if the
locomotive is not available the display will show "SE:L".
4. Now disconnect the DT100IR from LocoNet. The display should
immediately go blank .
or
)
5. Press & hold the direction arrow for the throttle side (either
you were using in step (1) & plug the DT100IR back into LocoNet.
52