Download Simulator User`s Manual
Transcript
5-13 Multislice calculations _______________________________________________________________________ 5.2. Imaging The Imaging property page allows the user to control the settings for the HREM images during the multislice calculations. Click on settings and then . 5.2.1. Defocus The defocus range can be assigned by selecting the starting point (start), the finish (end) and the step between start and end. If only one defocus value should be calculated then the start value must be equal to the end value. If the step is set to 0 and the start is different from the end, then only 2 defocus values will be calculated. The Save HREM check box sets the flag that indicates if the calculated HREM images should be saved in the corresponding files for later use. 5.2.2. Aperture The aperture radius value is in reciprocal Ångström (Å–1). It is possible to specify the centre of the aperture by changing the centre h and k values. NOTE: These values can be real. The (00) setting corresponds to the aligned aperture position. 5-13