Download Simulator User`s Manual

Transcript
5-13 Multislice calculations
_______________________________________________________________________
5.2.
Imaging
The Imaging property page allows the user to control the settings for the HREM
images during the multislice calculations. Click on settings
and then
.
5.2.1. Defocus
The defocus range can be assigned by selecting the starting point (start), the
finish (end) and the step between start and end. If only one defocus value should be
calculated then the start value must be equal to the end value. If the step is set to 0 and
the start is different from the end, then only 2 defocus values will be calculated.
The Save HREM check box sets the flag that indicates if the calculated HREM
images should be saved in the corresponding files for later use.
5.2.2. Aperture
The aperture radius value is in reciprocal Ångström (Å–1). It is possible to
specify the centre of the aperture by changing the centre h and k values. NOTE: These
values can be real. The (00) setting corresponds to the aligned aperture position.
5-13