Download 1. GENERAL CHARACTERISTICS

2-1
Connection procedure
If the place of installation of the oven corresponds to the recomendations
mentioned above, you can proceed with its connection.
To do this, carry out the following:
− You must be equipped with an circuit breaker and suitable cable.
− Install the circuit breaker then connect the cable.
For safety reasons, the circuit breaker must be switched off.
− Fasten the cable up to the back of the oven.
− Unscrew the cover of the box at the back of the oven.
− Unscrew the left stuffing box and thread the cable through.
− Allow some loose on the cable.
− Strip the wires cleanly.
− Wire according to the diagram opposite page.
− Screw the terminal screws tightly. The wires must not move in their
housings.
− Tighten the stuffing box. Allow some loose on the wires inside the
box.
− Screw back the cover to the electric box.
We advise you to contact our technicians or dealers in case of installation
problems.
RUBIS OVEN
16652
User manual
Page 8