Download Catalyst Lite Manual

CATALYST
4. Calibration
Calibration of chemicals with the Injection Controller is done on a per chemical
basis. This allows you to have extremely accurate injections of chemicals with a
wide range of varying specific gravity and viscosity. The flow properties of a
heavy, viscous surfactant will be quite different from those of a low viscosity acid.
Softrol Systems recommends that plant personnel become very familiar
with the types of chemicals they will be handling and the potential hazards
that are associated with each chemical. This information is contained in the
MSDS (Material Safety Data Sheet) supplied by the chemical vendors.
Softrol Systems also recommends that, at the very minimum, plant
personnel be required to wear all protective equipment recommended in
the MSDS.
Claibration Port
29
Catalyst
SOFTROL